Repiping and supply line replacement in Mt. Juliet

Many homes have a pressure regulator where the water enters the house. When it fails, you can see a leak, high pressure that stresses fixtures, or low pressure. Replacing it is a small job that can prevent a larger one.

A water line from the meter to the house is easy to overlook. It can be copper, plastic or galvanized, and it can be old. If the first few feet inside the house show corrosion, or the yard above the line stays wet, the main may be the problem. Replacing it is a smaller job than a whole-house repipe, and often fixes pressure complaints.

If your pipes bang when a faucet or an appliance valve closes suddenly, you are hearing water hammer. Moving water has weight, and when a valve slams shut the water has nowhere to go, so it sends a shock wave through the pipe. Over years, that can loosen fittings and damage valves.

Fixes include securing loose pipes so they cannot move, lowering the house pressure with a regulator, and adding arrestors, small devices that absorb the shock. A new repipe is a good time to add them at problem fixtures like the washer and the dishwasher. If your house has started to bang and did not before, tell us when it began. It sometimes means a regulator has failed.

Now and then we see a newer Mt. Juliet house with a single failing run: a line that was pinched, a fitting that was never seated, a section damaged when a trade cut through a wall. Repiping the whole house for that would be overkill. We replace the bad run, check the rest, and tell you what we found.

If a pattern shows up, such as the same type of fitting failing in several places, we say so and discuss what to do. Most of the time it is a one-off, and the fix is a few hours of work.