Water heater repair and replacement in La Vergne

A water heater in La Vergne has probably been replaced at least once since the house was built. The one you have now might be from the 2000s, a bit past its expected life, and starting to leak or lose capacity. If you are not sure whether to fix it or replace it, we will look at it and give you a straight answer.

What the day of a replacement looks like

We shut off the water and power or gas, drain the old tank, and disconnect it. The new unit goes in, connected to fresh shutoff valves, a proper relief valve and a discharge line. We fill it, check for leaks, relight or power up, and test the temperature. The old tank leaves with us.

Most tank swaps take a few hours. A change from tank to tankless takes longer, because the venting and gas supply often need work.

Before we start

  1. Check the label

    The tag on the old heater tells us size, fuel and age. A photo of it when you call speeds things up.

  2. Look at the space

    We see where it sits, how it is vented, and what is around it.

  3. Quote

    We give you a clear price and options. Free estimate.

A garage heater and everything around it

Water heaters in La Vergne garages tend to share a space with bikes, tools and storage shelves. Combustion air, clearance and a safe place for the relief valve to discharge are easy to lose track of when things pile up. On a gas heater, the burner needs room and clean air, and no one should be storing paint thinner or gasoline beside it.

If you are replacing a heater in a garage, it is a good moment to look at the whole corner and clear it out.

Gas and electric compared for a replacement

GasElectric
Recovery speedFasterSlower
VentingRequired and must draw properlyNone
Operating costDepends on gas priceDepends on electric rate
Switching fuelNeeds gas line and vent workNeeds a 240 volt circuit

More heater questions

Can I switch from electric to gas?

Sometimes, if there is a gas line nearby. It adds cost for the line and the venting.

How do I find the age of my heater?

The serial number on the label encodes the manufacturing date. Send us a photo of the label and we can read it.

Hard water and your heater

Middle Tennessee water tends to be hard because of the limestone. That builds sediment in tanks and scale in tankless units. Flushing a younger tank once a year helps. An old tank that has never been flushed can be risky to disturb, so we will tell you what we recommend.

What is included

  • Removal and hauling of the old heater
  • New shutoff valves and connections
  • Relief valve with proper discharge piping
  • Drain pan where the layout calls for it
  • Testing before we leave

Questions about heaters in La Vergne

Is tankless worth it?

For some homes, yes. If you have limited space or want continuous hot water it is a good option. It costs more up front and needs yearly descaling. We will give you both prices.

What size do I need?

It depends on how many people live in the house and how many bathrooms you have. We size it so the shower and the dishwasher can run without a fight.

The anode rod, the cheapest part of a heater

Inside most tanks is a metal rod, usually magnesium or aluminum, that corrodes in place of the steel tank. It is called an anode rod, and it is the reason a tank lasts as long as it does. When the rod is gone, the water attacks the tank walls, and a leak is not far behind.

On a tank that is five or six years old, checking the rod is worthwhile. If it is mostly consumed, a new one costs little and can add years. On a tank that is already past ten, the rod is rarely worth chasing. Hard water eats the rod faster, and in this part of Middle Tennessee it is worth looking at earlier than the textbook says.

Water Heaters in La Vergne?

(423) 227-6947

Call or text, or send us a message and we will get back to you.

Call now Free quote