Repiping and supply lines in Nolensville
Most of Nolensville's houses are new enough that repiping is not a concern. The exceptions are the older buildings along Nolensville Road and nearby streets, some of which have plumbing that dates back decades. If you own one of those, repiping may be on the horizon.
Historic houses and supply lines
Older homes along Nolensville Road can have galvanized steel or older copper supply lines. They tend to leak at joints or lose pressure as rust narrows the pipe. Replacing them is often a good moment to update shutoff valves and address any questionable fittings.
Signs your supply lines are tired
- Brown water when you first open a tap
- Pressure that is fine at the main but weak at the far fixtures
- Frequent leaks at joints
- Visible corrosion on exposed pipes
Phasing the work in an older house
A repipe does not have to happen in one burst. In an older Nolensville house, we may start with the worst section, such as the kitchen run or the main from the meter, and leave the rest for another season. It spreads the cost and keeps you in the house. The tradeoff is a longer process overall and some patching in more than one place.
We discuss both approaches so you can choose.
Where to start in an older house
- The main line from the meter to the house
- Runs that have leaked before
- Lines to the water heater
- Kitchen and bathroom branches
More repipe questions
What if my house has more than one type of pipe?
That is common. We map what you have and plan so the transitions between materials are done correctly.
Will you check the pressure regulator?
Yes, and replace it if it is failing.
How we approach it
Look
We see what you have and where it is failing.
Plan
We decide how to route new lines with minimal wall openings.
Replace
Install, test and reconnect everything.
Repipe questions
Is my new house at risk?
Not usually. New homes use PEX or copper in good condition. A fitting failure is more likely than a pipe failure.
Can you repipe an old house without wrecking the walls?
We plan the route carefully and keep openings small. Some access is always needed.
The pressure regulator and why it matters
Water pressure from the street can be well above what a house needs. A regulator at the main brings it down to a safe level, usually somewhere around 50 to 60 psi. When the regulator is working, the whole house runs at a steady pressure. When it fails, you can see anything from banging pipes and dripping faucets to a washing machine hose that bursts.
A regulator is a small valve with a diaphragm that wears out in ten to fifteen years. If your house is older than that and has never had one replaced, it may be on borrowed time. Replacing it is much cheaper than any repipe, and it protects the pipes you already have.
More repipe questions from Nolensville
What should I check in a new house to avoid future problems?
Find the main shutoff and the pressure regulator, check the water heater, and look for any drips at fixtures. Early checks catch small things.
Is PEX safe for drinking water?
Yes. It is approved for potable water and used in the majority of new construction.
Old Nolensville houses, a quick note
If you own one of the older houses along Nolensville Road, look at the supply lines in the crawlspace first. That is where the most information is. Take photos and send them. We will tell you if we see anything that concerns us and, if not, we will say so.
More plumbing in Nolensville
- Leak Detection & RepairHidden leaks in old Nolensville Road homes and in the first years of new construction.
- Water HeatersTank and tankless water heater replacements in Nolensville, from old farmhouses to new builds.
- Drain Cleaning & SewerClogged sinks and main lines cleared in Nolensville, plus drain repair in older homes.
- Remodel & New Build PlumbingRough-in, finish plumbing and basement baths for Nolensville builders and homeowners.
- Fixtures & InstallsFaucets, toilets and vanities installed in Nolensville, from new homes to old town houses.
Repiping & Supply Lines nearby
- Repiping & Supply Lines in MurfreesboroReplacing worn galvanized and copper lines in older Murfreesboro homes, one run or the whole house.
- Repiping & Supply Lines in SmyrnaReplacing worn supply lines in Smyrna homes, from a single failing run to a whole-house repipe.
- Repiping & Supply Lines in FranklinReplacing old supply lines in historic Franklin homes with as little damage as possible.
- All repiping & supply lines service areasSee every city we cover for this service.
- Plumber in Nolensville, TNAll our work in Nolensville, from one page.
Repiping & Supply Lines in Nolensville?
(423) 227-6947Call or text, or send us a message and we will get back to you.