Water heater repair and replacement in Eagleville

Water heaters out in the county tend to be forgotten until they fail. They sit in a utility room, a closet or a crawlspace, and nobody checks the pan, the valve or the connections. When they quit, it is usually on a cold morning.

Common questions

How can I tell if my heater is on its last legs?

Age is the first clue. Past ten years, you are on borrowed time. Rumbling, rust-colored water, and moisture at the base are the others.

Can you replace a heater in a crawlspace?

Yes. It takes more care, since access is tighter and the old unit has to come out. We tell you what the job involves before we start.

Do I need a drain pan?

If the heater sits above living space, or the floor around it would be damaged by a leak, yes. We install one and run a drain line wherever possible.

Hard water out here

Water in this part of Middle Tennessee runs through limestone and tends to carry a lot of dissolved minerals. If you are on a well, it can be harder still. That means sediment in the tank and scale on elements, and shorter life if nobody flushes the tank. A water softener helps, but you do not need one to get a good heater. Flushing it once a year helps.

Farmhouse heaters

In older houses, the heater may have been moved or replaced several times, and each change left something behind: a shutoff in an odd place, a vent that was not updated, a pan that was never added. When we replace a heater in a house like that, we look at the whole corner and bring it up to date.

If the old tank is in a crawlspace under a floor, the job takes longer, since the new tank has to be passed down through a small opening.

Questions that decide the job

  • Is the heater in the house, a garage or a crawlspace
  • Gas, propane or electric
  • Is the water from a well, which may carry sediment
  • How many people live in the house

More heater questions

I am on propane. Can you replace a propane heater?

Yes, as long as the fuel type and connections are handled correctly. Tell us when you call.

Does well water shorten a heater's life?

It can, if it carries a lot of sediment or minerals. A filter helps, and so does flushing.

On a replacement we handle

  • Draining and removing the old tank
  • A relief valve with proper discharge piping
  • New shutoff valves and fittings
  • A pan and drain line where needed
  • Testing before we leave

Wells and heaters

If you are on a well and your heater is losing pressure or the water has sand in it, that may be a well or sediment filter issue and not the heater. We look at the whole setup.

Before the day we swap yours

A water heater replacement goes faster when the space is ready. Clear a path to the heater, move anything stored around it, and if it is in a crawlspace or attic, make sure the access is open. Let us know about pets, and where the cold water shutoff is if you know it. We will turn off the gas or power ourselves.

If the house has been on a well and the water has sand in it, tell us. A heater full of grit behaves differently from one full of scale, and it may change what we recommend for the new unit and how we plumb it in.

Water Heaters in Eagleville?

(423) 227-6947

Call or text, or send us a message and we will get back to you.

Call now Free quote